Global One Construction Solutions LLC

Menu
Login

SIKAFLEX 1A 10oz

One Part Polyurethane Elastomeric Sealant/Adhesive 

24 tubes/case | Price listed is per tube

Be the first to review this product

Availability: In Stock

Check Availibility & Pricing

Sikaflex 1A is a premium-grade, solvent-free, high-performance, moisture-cured, 1-component, polyurethane-based, non-sag elastomeric sealant.

Sikaflex 1A can be used in green and damp concrete applications. Meets Federal SpecificationTT-S-00230C, Type II, Class A. Meets ASTM C-920, Type S, Grade NS, Class 35, use T, NT, O, M, G, I.

Where to Use 

Advantages 

  • Eliminates time, effort, and equipment for mixing, filling cartridges, pre-heating or thawing, and cleaning of equipment.
  • Fast tack-free and final cure times.
  • High elasticity – cures to a tough, durable, flexible consistency with exceptional cut and tear-resistance.
  • Stress relaxation.
  • Excellent adhesion – bonds to most construction materials without a primer.
  • Excellent resistance to aging, weathering.
  • Proven in tough climates around the world.
  • Odorless, non-staining.
  • Jet fuel resistant.
  • Certified to the NSF/ANSI Standard 61 for potable water.
  • Urethane-based; suggested by EPA for radon reduction.
  • Paintable with water-, oil- and rubber-based paints.
  • Capable of ±35% joint movement. 

Limitations

  • When overcoating with water, oil and rubber based paints, compatibility and adhesion testing is essential.
  • Sealant should be allowed to cure for 7 days prior to overcoating.
  • Avoid exposure to high levels of chlorine. (Maximum continuous level is 5 ppm of chlorine.)
  • Maximum depth of sealant must not exceed 1/2 in.; minimum depth is 1/4 in.
  • Maximum expansion and contraction should not exceed 25% of average joint width.
  • Do not cure in the presence of curing silicone sealants.
  • Avoid contact with alcohol and other solvent cleaners during cure.
  • Do not apply when moisture-vapor-transmission condition exists from the substrate as this can cause bubbling within the sealant.
  • Use opened cartridges and uni-pac sausages the same day.
  • When applying sealant, avoid air-entrapment.
  • Since system is moisture-cured, permit sufficient exposure to air.
  • White color tends to yellow slightly when exposed to ultraviolet rays.
  • Light colors can yellow if exposed to direct gas fired heating element.
  • The ultimate performance of Sikaflex-1a depends on good joint design and proper application with joint surfaces properly prepared.
  • The depth of sealant in horizontal joints subject to traffic is 1/2 in.
  • Do not tool with detergent or soap solutions.
  • Do not use in contact with bituminous/asphaltic materials. 

Approvals/Standards

  • ASTM C 920, Type S, Grade NS, Class 35, use NT, A, M
  • Federal specification TT-S-00230 C Type II, Class A
  • Canadian Standard CANICGSB 19.13-M87
  • Certified to NSF/ANSI standard 61 for portable water

Color

White, colonial white, aluminum gray, limestone, black, dark bronze, capitol tan, stone and medium bronze. Special architectural colors on request.

Additional Documents

  • Color Chart 
  • Product Data Sheet
  • SDS
  • Sikaflex Sealant Brochure
  • Spec Component
  • Case Study

WARNING

This product can expose you to chemicals including Quartz (SiO2), which are known to the State of California to cause Cancer & Reproductive Harm.